Performance problem in QuickTableFilterField

[Nachiyappan]

Hi

I am doing searching using QuickTableFilterField in a table, which contains 20,000 rows and 100+ columns.

The performance is very slow. Is there any provision to improve its performance.

Thanks & Regards

[JIDE Support]

Is it possible that you use QuickTableFilterField#setSearchingColumnIndices() to limit the search to several columns? The reason is that, we will have to search every cell to decide if the rows should be filtered or not. Hence, one character input will cost 20,000*100=2,000,000 compare, which is expensive.

Thanks,

[Nachiyappan]

yes.. exactly the same.

But I need to search all the columns in the rows.

Is there any posiblity to override the search operation done in each key operation and to be done in enter key action.

Thanks in advance

[JIDE Support]

Please try invoke QuickTableFilterField#setSearchingDelay(-1) to do search only on enter key.

Thanks,

[Nachiyappan]

Thank you..

Filter is working for enterkey event. But if I clear the field, that time too I need to give enter key to clear the filter. I dont want that...

If the field get cleared, the filter also have to remove.

Please give ur valuable suggestions.

[JIDE Support]

Thanks for suggestion. Will fix it in 2.8.2.

Thanks,

[JIDE Support]

Just so you know, this is fixed in 2.8.2.

Thanks,